HowTo/Scenery/mesh-table/att - Revision history

Glt0145: /* att */

2022-02-05T23:17:59Z

att

← Older revision		Revision as of 23:17, 5 February 2022
Line 8:		Line 8:
	This is the name of the attachment point within your mesh where the text will be displayed. When creating your mesh the orientation of the attachment point is important. if it is incorrect your text may not display.		This is the name of the attachment point within your mesh where the text will be displayed. When creating your mesh the orientation of the attachment point is important. if it is incorrect your text may not display.

	When creating your mesh your attachment point for your text should always start with "a." followed by a meaningful name. Examples "a.name" or "a.signalname"		When creating your mesh your attachment point for your text should always start with "a." followed by a meaningful name. Examples "a.name" or "a.signalname". In the case of a corona (light) attachment point might be named "a.light".

Glt0145: /* att */

2022-02-05T22:50:59Z

att

← Older revision		Revision as of 22:50, 5 February 2022
Line 7:		Line 7:

	This is the name of the attachment point within your mesh where the text will be displayed. When creating your mesh the orientation of the attachment point is important. if it is incorrect your text may not display.		This is the name of the attachment point within your mesh where the text will be displayed. When creating your mesh the orientation of the attachment point is important. if it is incorrect your text may not display.

			When creating your mesh your attachment point for your text should always start with "a." followed by a meaningful name. Examples "a.name" or "a.signalname"

Glt0145: Created page with " == att == This tag is compulsory when creating a "kind" "name" effect. Data type is a string so it has to be surrounded by "". This is the name of the attachment point wit..."

2022-02-05T22:37:53Z

Created page with " == att == This tag is compulsory when creating a "kind" "name" effect. Data type is a string so it has to be surrounded by "". This is the name of the attachment point wit..."

New page

== att ==

This tag is compulsory when creating a "kind" "name" effect.

Data type is a string so it has to be surrounded by "".

This is the name of the attachment point within your mesh where the text will be displayed. When creating your mesh the orientation of the attachment point is important. if it is incorrect your text may not display.